|

(0)

|

|

|

|

Racing » Products » ECU interfaces » CAN interface

ECU interface - CAN

What is the CAN interface?

The Race Technology CAN interface is a small in-line module for use with a DASH1 or DASH2 display, a DL1 or DL2 data logger or any combination of data logger plus display, to allow data from your engine management system to be displayed and recorded.

Who is the CAN interface designed for?

The CAN interface is designed for anyone wishing to read vehicle or drive train sensor data directly from their ECU or other CAN device, without the need for additional sensors. Common parameters such as engine speed, coolant temperature, throttle position, etc, are normally available from the ECU, so no additional sensors would be required if using the CAN interface. This leaves the analogue input channels on your data logger free for connection to more specialised sensors, not normally monitored by your ECU (eg: suspension travel). ECUs are being added to the compatibility list all the time. Please contact Race Technology to confirm compatibility with your ECU.

NOTE:  The CAN interface is only compatible with CAN BUS vehicles / ECUs.  If in doubt please consult your vehicle agent or ECU manufacturer. 

Key Features

• Compatible with Race Technology displays and data loggers as stand alone units, or as part or a data logger and display system
• CAN and serial models available, compatible with a wide range of ECUs
• Receive data from existing vehicle sensors via your ECU - no need to add additional sensors for data logging
• All channels from ECU are in addition to the channels already provided with the Race Technology data logger/display
• CAN interface fully user configurable with software supplied. Programable for virtually any vehicle or ECU using standard CAN protocols. Select which channels to receive and decode
• Upgradeable firmware. Both the CAN and serial interfaces are flash upgradeable with firmware updates
• Inline electronics encased in a tough injection moulded case
  
• Supplied with cables, instruction manual and comprehensive software CD

CAN interfaces for the following ECU's can be supplied with a pre-configured CAN set-up:

Most modern BMWs	Life Racing
Corvette LS3	MBE
Bosch MS4.3	Most modern Mercedes
DTA	Motec
EFI	Pectel
Electromotive	Most modern Porsches
Emerald	Syvecs
GEMs	Tour de force
Haltech	Gumpert
KMS	OMEX
KTM x bow

For further information on the CAN ECU Interface please visit our Knowledge Base here