Hi Life F88. Any chance you can mail me the CCF file?

Simon

Is it possible to load the CCF file from the CAN interface to a computer? If so how?

Simon

Hi, Thanks for that. Found another way as well. open Variables manager In external inputs I pick an unused analog channel. eg 12 Open sensor type select custom Bottom left window lists all current channels Select channel you want to use data from eg 10 You can now process this data as you want and i...

I want to plot damper deflection in mm plus damper speed (diferentiation of deflection) as two charts (or plots on same chart) from one data set Any know if this is possible?

Cheers

Simon

HELP, At Silverstne for shakedown test of new car tomorrow, DL1 with Dash 2 All was working OK till I turned on car this evening, now DL1 is frozen All LEDs lit. I have tried:- Reseating all cables Reseating CF card Reformat CF card Replace CF Card Disconnected GPS cable Disconnected Dash 2 Tried Mo...

Hi Raba,

Are you using a DL1 or just the Dash 2 if Dash 2 only I think you have to use the Dash2 analogue channels

http://www.race-technology.com/wiki/ind ... ogueInputs

Regards

Simon

Hi, Has anyone got any knowledge of using PI Research sensors. I am relacing my PI system 1 with a DL1 and want to use the temp sensors (RTD). It's the formula I need

Simon

Hi, got the rest of the issues sorted thans to RT but no I still cannot get this working. I got lap times once by programming a button on the DL2 to manually place a marker, but this did not get picked up on the second session. RT, Is there a setting somewhere to enable the Dash 2/DL1 to read the ma...

Help!!

Simon

Help, At Brands with a Dash2 that will not show RPM or any resonable response to changes in oil P or water temp. The data logger is working fine and the sensors are ok as I can see them wotking on the analysis SW. When I switch on the Dash 2 it seems to take a long time to configure itself - the lit...

HI Al. Got the mail thanks The dash somtimes only displays the rpm scale - but no RPM and no other segments. Powering off and on fixes it but only if there's a config file on the CF card I've loaded a LAP file several times but the dash does not show any lap timimg, right format, same track etc The ...

I ran my dash 2 dl1 in anger today for the first time and had the following problems:- 1. The Dash sometimes came on without all of the display, seems like it lost the config 2. Lap timing - for the life of me I could not figure out how to get this to work 3. OIl pressure, went to 133 psi and stayed...

SO I'm getting closer to getting it fully working. Got all the sensors reading correctly and all the settings on the dash OK. THe Data logger is logging the data correctly as well. LAst problem is the RPM. I cannot seem to get this sorted. I'v got a screened cable running to the data logger from the...

Anyone know how I can set the serial port sample rates to 100hz from the 5 they are now? I have tried using the config SW but that only offers the option to save to a file.

Regards

Simon

www.tillingmotorsport.com

Picked up my repaired dash from the Race Tech stand at the autosport show - Thanks Race tech!