Thanks for this info.
I had the same response from Martin at RT UK. The x3 give an aprox figure, ok as a start but was expecting the DL1/Dash1 to be more accurate than my OEM Tacho.
Tricky
Search found 4 matches
- Mon Mar 27, 2006 1:13 pm
- Forum: General support questions
- Topic: DL1 - No RMP input
- Replies: 5
- Views: 9588
- Wed Mar 22, 2006 6:55 am
- Forum: General software support
- Topic: Dash1 buttons not transmitting to DL1
- Replies: 4
- Views: 9490
- Wed Mar 22, 2006 6:46 am
- Forum: General support questions
- Topic: DL1 - No RMP input
- Replies: 5
- Views: 9588
RT Support, Yes you are correct. The Dash1 appears to show 1/3 of actual revs. I tried moving the I/P wire to the "Spark in" and there was no change i.e indicated RPM was about 1/3 of actual. Also tried grounding the "Spark GRND" and this gave spurious readings in the 1.000s Then tried adjusting the...
- Tue Mar 21, 2006 8:44 pm
- Forum: General support questions
- Topic: DL1 - No RMP input
- Replies: 5
- Views: 9588
DL1 - No RMP input
Installed my new DL1/Dash1 today but I can not get the RPM I/P to work using DL1 5v Tacho I/P. ROVER K series with MEMS 3. I have spliced into the tacho wire which with no load shows 3.xx Volts at idle, so I believe this is a 5V O/P. RPM reads Aprox. 275 and when the revs are increased the Dash1 see...