Search found 9 matches

by dboyles
Sat Jul 21, 2007 10:07 pm
Forum: General support questions
Topic: Auto Start/Stop bugs
Replies: 9
Views: 13380

edit: Previous stuff deleted from this post because I figured out the "issue." See below. Okay, after some more testing it comes down to this: I wasn't understanding what the DL1 was doing. When I first turn the unit on and put a card in, there is a delay of about 27 seconds before the dat...
by dboyles
Thu Jul 19, 2007 7:25 pm
Forum: General support questions
Topic: Auto Start/Stop bugs
Replies: 9
Views: 13380

I'll do some additional tests soon and report back with my results.
by dboyles
Thu Jul 19, 2007 3:00 pm
Forum: General support questions
Topic: Auto Start/Stop bugs
Replies: 9
Views: 13380

At my last autocross event I had some issues with auto start triggering when it shouldn't. I was using the same configuration as before (with the 35 km/hr auto start threshold) but it was triggering between when I powered up and when I got to the start line. I'd even reach down and stop it manually,...
by dboyles
Wed Jun 20, 2007 10:17 pm
Forum: General support questions
Topic: Auto Start/Stop bugs
Replies: 9
Views: 13380

Raising the auto stop threshold to 30 (i.e. 3 km/hr) worked like a charm. But after some experimentation I think I'm going to leave auto stop disabled because it seems to take away the ability to manually start logging when the vehicle is stationary (because it immediately stops it). I do like auto ...
by dboyles
Tue Jun 19, 2007 2:42 am
Forum: General support questions
Topic: Auto Start/Stop bugs
Replies: 9
Views: 13380

Whoops, the problem with the test.run file was with permissions - fixed now. Yes on the 1 minute between GPS lock and insertion of the card. I left the system running while I went back inside and formatted the card. And yes, everything works fine prior to the current setup.bin (with auto start/stop ...
by dboyles
Tue Jun 19, 2007 12:03 am
Forum: General support questions
Topic: Auto Start/Stop bugs
Replies: 9
Views: 13380

Auto Start/Stop bugs

I'm seeing some weirdness/inconsistency with auto start/stop configuration settings. Specifically, auto start seems to trigger sporadically (it starts when it's supposed to, but also at other times) and auto stop hasn't worked yet. This is with firmware 8-5 and software 6.3.121. Here's what I did: &...
by dboyles
Mon Jun 18, 2007 8:23 pm
Forum: General software support
Topic: Adding sectors programmatically - issues?
Replies: 2
Views: 7032

Thanks for the reply, Jason. I'll give that a shot (defining start/finish/sectors based on one run). However, one issue I've run into seems to be a common one - dealing with GPS drift over time. I'm finding that runs that are only an hour or so apart are several meters off on the start. It's bad eno...
by dboyles
Mon Jun 18, 2007 2:30 am
Forum: General software support
Topic: Adding sectors programmatically - issues?
Replies: 2
Views: 7032

Adding sectors programmatically - issues?

I was autocrossing this weekend and put my DL1 through its virgin runs in my car and in a friend's. I'm doing analysis now, and I can't seem to get run times to make sense relative to the official times at the event. I can get a pretty accurate "start of run" marker by looking at the longi...
by dboyles
Wed Jun 13, 2007 1:57 am
Forum: Installation questions
Topic: Using the new style DL1 rear connector
Replies: 4
Views: 60226

Image

Go to advanced search