Search found 6 matches

by automotion.co.nz
Wed Feb 22, 2012 7:47 am
Forum: Sensor-related questions
Topic: Has anyone tried logging shock velocities? Sample rate ok?
Replies: 24
Views: 59370

Can you post a screen shot without the graph points joined?

What sensors are you using?
by automotion.co.nz
Fri Nov 14, 2008 3:40 am
Forum: Installation questions
Topic: Installation in a Formula 5000
Replies: 4
Views: 10065

I have a non contact crank sensor on the way. Thanks for the 'heads up' on the faraday box. I'll do some research on these and make a call. I won't be at Eastern Creek as I have a clash with our domestic series and I am otherwise committed. My guy Adam is spannering Tony Richards Lola 332 so they'll...
by automotion.co.nz
Thu Nov 13, 2008 6:20 pm
Forum: Installation questions
Topic: Installation in a Formula 5000
Replies: 4
Views: 10065

Hello, Reply from Race Technology FYI "If the car has a capacitive discharge system then it can be very easy to damage the DL1. I would strongly recommand a seperate battery pack and mount the DL1 as far away from the ignition system as possible. The perfect solution would be not to connect any...
by automotion.co.nz
Sun Nov 09, 2008 9:49 am
Forum: Installation questions
Topic: Installation in a Formula 5000
Replies: 4
Views: 10065

Installation in a Formula 5000

I am intending fitting my DL-1 and dash 3 to a customers Lola 332 Formula 5000. The ignition system has a magneto fitted. Are there any special precautions I need to take or issues to be aware of? I will use a battery rather than connect to the cars electrical system in any way. Is connecting a wire...
by automotion.co.nz
Sat Nov 01, 2008 7:28 pm
Forum: General software support
Topic: monitor. not working
Replies: 15
Views: 40583

This was a big help

I got tripped up using a gender changer trying to connect to DL1 to use moniter/lite moniter AND I didn't realise that there were differences in serial cables. I had a long cable to the usb adaptor that worked fine. I replaced it with the short serial cable that I use between VOB and DL1 and it all ...
by automotion.co.nz
Sat Nov 01, 2008 7:22 pm
Forum: General software support
Topic: Quick way to expand tables etc
Replies: 1
Views: 5305

Quick way to expand tables etc

It used to be that in any layer you could double click on the top of any table/graph/whatever and it would expand to full screen. Double click again and it would snap back to its original position.
I no longer seem to be able to do this on all options
Am I missing a trick? :(

Go to advanced search