osborni wrote:DTA should list the pulses per rev that it pushed out the CAN bus. Check their manual or if they have a forum.

DTA forum
http://dtaforum.psycode.com/index.php

I wonder if one of the techy guys could have a quick look at the following post and offer up a solution Please.

http://www.race-technology.com/forum/vi ... =7011#7011

Curently pulling out what little hair I left whilst looking at the offerings available from STACK

Anyone got any idea as to which resistors I'll need. I'm currently unable to get the bloody thing working/reading sensors without this little bit of much needed info. Wanted Stack ST81XX dash and logger sytem. Will swap/PX for a relatively new/low mileage (160ish miles of use on a demo car) Dash2 an...

I forgot to ask.

What load ratings should i be looking for
1K ohms?
or some other rating??

That's what i needed to know.

Thanks folks

I should have made my post a little clearer.

I'm looking for resistors to fit between the +12 and 5v feed on my bosch sensor's(IAT/Water temp),TPS and map sensors so the Dash2 and DL1 can recognize the signal.

I'm having some difficulty finding 1W resistors locally but can get hold of 0.6W and 2W ones easily enough.

Would any of those 2 be suitable?
If so, which ones. The 0.6W or the 2W?

Ta in advance

Thanks.

Any idea as to what would be the relevant numbers needed in order to display pressure in Psi??

Just a quick Q re the C/F card I've aquired a Dash2 and DL1 but there's no C/F card with it Which ones can i use does it work with the high speed ones(133x/300x etc) or just with the "normal" ones Which capacity would have been shipped with the unit from the factory?? Cheers in advance

sorted now(i think)

I get the same message with my Expresscard54 to serial adapter and it won't connect to the display or the logger

Would a usb-serial work??