Search found 4 matches

by Clive Austin
Fri Jun 12, 2015 5:18 pm
Forum: General support questions
Topic: Failure to start logging on Dash 4 pro
Replies: 2
Views: 5466

This was traced to an issue within the latest firmware which checks the logger serial number - mine was quite an early device and this has caused problems. The fix was RT changing the serial number on my logger via GoTo Assist. Not sure if there will be a change to the firmware as a result but if an...
by Clive Austin
Sun Jun 07, 2015 10:04 pm
Forum: General support questions
Topic: Failure to start logging on Dash 4 pro
Replies: 2
Views: 5466

Failure to start logging on Dash 4 pro

Last week I upgraded the firmware on my DL1 Mk3 and Dash 4 Pro. However, when I press the set key to start logging I get a message saying failure, command time out and no logging indicator is displayed in the dash. Having said that, the lights on the unit indicate that the dl1 is actually logging. A...
by Clive Austin
Mon May 25, 2015 4:23 pm
Forum: General support questions
Topic: Unable to display data on some channels from ECU in Analysis
Replies: 3
Views: 7437

Hi Sam, I have the same issue as Rob. I have samples showing but they flatline. I am taking CAN data from DTA S100 for a range of variables successfully. However, I am not seeing 'good data' for crank errors, cam errors and analogue 3 gear pot voltage. I have tried resetting Analysis but even he def...
by Clive Austin
Wed May 26, 2010 11:09 pm
Forum: General software support
Topic: External shift light / Dash 3 / DL1
Replies: 1
Views: 5506

External shift light / Dash 3 / DL1

Is it possible to drive an external shift light from the Dash 3 / DL1 combination to supplement the shift lights on the Dash 3? Ideally I want to mount a hi vis LED right in my line of sight where as the Dash 3 is slightly lower in the cockpit.

Thoughts wlcome.

Thanks

Clive

Go to advanced search