Search found 4 matches
- Fri Jun 12, 2015 5:18 pm
- Forum: General support questions
- Topic: Failure to start logging on Dash 4 pro
- Replies: 2
- Views: 5585
This was traced to an issue within the latest firmware which checks the logger serial number - mine was quite an early device and this has caused problems. The fix was RT changing the serial number on my logger via GoTo Assist. Not sure if there will be a change to the firmware as a result but if an...
- Sun Jun 07, 2015 10:04 pm
- Forum: General support questions
- Topic: Failure to start logging on Dash 4 pro
- Replies: 2
- Views: 5585
Failure to start logging on Dash 4 pro
Last week I upgraded the firmware on my DL1 Mk3 and Dash 4 Pro. However, when I press the set key to start logging I get a message saying failure, command time out and no logging indicator is displayed in the dash. Having said that, the lights on the unit indicate that the dl1 is actually logging. A...
- Mon May 25, 2015 4:23 pm
- Forum: General support questions
- Topic: Unable to display data on some channels from ECU in Analysis
- Replies: 3
- Views: 7894
Hi Sam, I have the same issue as Rob. I have samples showing but they flatline. I am taking CAN data from DTA S100 for a range of variables successfully. However, I am not seeing 'good data' for crank errors, cam errors and analogue 3 gear pot voltage. I have tried resetting Analysis but even he def...
- Wed May 26, 2010 11:09 pm
- Forum: General software support
- Topic: External shift light / Dash 3 / DL1
- Replies: 1
- Views: 5552
External shift light / Dash 3 / DL1
Is it possible to drive an external shift light from the Dash 3 / DL1 combination to supplement the shift lights on the Dash 3? Ideally I want to mount a hi vis LED right in my line of sight where as the Dash 3 is slightly lower in the cockpit.
Thoughts wlcome.
Thanks
Clive
Thoughts wlcome.
Thanks
Clive