Cheers for that, I re formatted and tried again. Reformat FAT Allocation unit size 32Kb (not quick format) 1st 20 min run - logging started correctly, could not stop the logger by switch or serial command. DL1 switched off whilst logging, 51.51 seconds recorded 2nd 20 min run - logging started corre...

We had assumed we had fixed it, however these tests were static, i.e. bike not moving.

When we actually ran the bike late yesterday, we could stop the logging by either the hardware switch or by the serial link. After 25 mins we had 36 seconds of data.

Any ideas?

Update, Seems there is a problem with the serial link. All data sent from the DASH2 to the DL1 is recorded, but the serial command to stop logging does not seem to be working.

Wired in a separate logging switch and it all works smoothly. Strange but I have it working

Hi, I have a DL1 connected to a DASH 2 with the DASH 2 configured to enable logging via a button (serial link) Once bike started I start logging by pressing the button, the LHS shift light turns on and a tick appears on screen. However logging may or may not have started (based on the file times). I...

cheers regedit it is

Arron

Hi,
I'd like to move the swap file to an SSD drive. Changing its size is easy, but unclear how to change it's location.

cheers

Arron

hi, i'm away from my kit and just planning an installation. Does anyone know if its possible to download run data from a DL1 mk2 with a serial lead rather than removing the compact flash? Installation I'm planning will not give easy access to the DL1 so i'm looking for an alternative. I have conside...

hi, lost GPS lock. Gps lock light is permanently off Status Light flashing (a pattern of some form) Date / time (from gps) reported as 6th jan (assume that means no lock) checked antenna cable, seems ok, no kinks or obvious impressions clear view of sky, etc tried with / without memory card fitted a...

Issue with the 9.2.7 firmware, advised to reflash with earlier version

All works now

Hi, I've used the config tool for the DASH2 to change the RPM range from 8K to 13K. I transferred the config change via the serial link, and all updates are reflected in the DASH2. If I power cycle the DASH2 then I lose the adjusted RPM scale, but all the other changes remain. I then tried to update...