Search found 2 matches
- Tue May 13, 2014 6:51 am
- Forum: General support questions
- Topic: 2 problems (update + rpm-signal) (Tatech32 & DL1Mk2 &
- Replies: 0
- Views: 25814
2 problems (update + rpm-signal) (Tatech32 & DL1Mk2 &
I have Tatech Ecu & DL1Mk2 + Dash3. I have been trying to get RPM data into Dash 3. I found solution in which I should disable analog RPM channels from DL1Mk2 setup. 1) tried to run SETUP.BIN into DL1. After trial, now I have these errors: - unable to update dash3 with DASH.HEX file - before it ...
- Fri May 24, 2013 8:03 pm
- Forum: General software support
- Topic: Video Synchronizer working???
- Replies: 7
- Views: 14205
Issue syncing with led
I installed the sync led and tested it with video.
led is really dim - is this normal? It is visible to human eye but not visible in the videos.
I powered it from the same source than the DL1 (the cigarrette lighter). Is the power too low for the led?
analysis software does not find the sync.
led is really dim - is this normal? It is visible to human eye but not visible in the videos.
I powered it from the same source than the DL1 (the cigarrette lighter). Is the power too low for the led?
analysis software does not find the sync.