Oke this looks good....but my DL1 MK1 flashing to new firmware? Is this not triggy? And the documentation does say something about the protocol, but when I send it on an RS232 line. Nothin happens. Say I want to send a TPS signal (say 60%) to the DL to log. Can you give us a example message? Hex or ...

Really no answer? Or is this forum dead? To bad. Even though the product looks great (The DL1) a good service/support is also a selection criteria. Did buy an older DL1 to try all this out.... Making the anser more simple: Does the DL1 MK1 does support incomming sensor values on the serial port? Or ...

Ever fixed this and got an answer? Have the same question and also have seen the same question in 2011....this is even 2008!

I have the same question. But your thread is from 2011! Did you ever got an answer?

I am busy developing a solution to use the DL! with my K/Line. Off course I can install all cables to al the sensors and let the DL! poll each sensor with the frequencies. But I want to send the variables from the K/Line serial to the DL1. I have been reading that you can send values to the DL1 MK1 ...

I want to connect an CBR 1000RR to my DL1 MK1. But the ECU has a K-Line. Does the DL1 send ECU messages? Or is it passive? And what are the best ways to use my DL1 MK1 to my CBR 1000RR from 2010?