Search found 5 matches

by glen.donhardt
Thu Mar 16, 2017 11:31 am
Forum: General software support
Topic: DASH2 RPM not displaying
Replies: 5
Views: 15249

Re: DASH2 RPM not displaying

Problem resolved.

The ECU signal was not being pulled fully to ground. dropped to approx 2 volts.
Removing the 1k pull up resistor to +12 volts fixed the issue.
I tried a 5k pull up, it also failed.

Thanks for your assistance.
Glen
by glen.donhardt
Wed Mar 15, 2017 11:57 am
Forum: General software support
Topic: DASH2 RPM not displaying
Replies: 5
Views: 15249

Re: DASH2 RPM not displaying

Reflashed to 9.3.4
reloaded config file
No difference in the result.

Regards
Glen
by glen.donhardt
Wed Mar 15, 2017 11:20 am
Forum: General software support
Topic: DASH2 RPM not displaying
Replies: 5
Views: 15249

Re: DASH2 RPM not displaying

The RPM signal is direct to the Subaru ECU.
Connector B137 Pin 9.
This in the standard car goes direct to the dash cluster.

I will try and reflash now and report back.

Thankyou
Glen
by glen.donhardt
Wed Mar 15, 2017 10:51 am
Forum: General software support
Topic: DASH2 RPM not displaying
Replies: 5
Views: 15249

Re: DASH2 RPM not displaying

Sorry, I should mention the dash2 setup is:
RPM RS232 - NO
DASH2 RPM - YES
by glen.donhardt
Wed Mar 15, 2017 10:46 am
Forum: General software support
Topic: DASH2 RPM not displaying
Replies: 5
Views: 15249

DASH2 RPM not displaying

Hi I am new to this forum and seeking some assistance in configuring the RPM display on a DASH2. (standalone) The RPM signal is a clean 33-40Hz 12 volt square wave at idle. 1k pull up to +12 volts, version 9.1.7 firmware ECU is standard Subaru WRX 2005. The motor is in a custom manx style buggy. RPM...

Go to advanced search