Search found 4 matches

by anthony pearce
Wed Oct 10, 2018 11:37 am
Forum: Pre-sales product questions
Topic: engine system malfunction indicator and warning light.
Replies: 2
Views: 131

Re: engine system malfunction indicator and warning light.

Are you confirming that I can connect the ECU Malfunction indicator signal from the ECU using the single cable since the ECM output signal is going tobe a voltage, varying between malfunction present at less than 1v, while no malfunction is 10to 14v. I am expecting that this will give the alarm when...
by anthony pearce
Sun Oct 07, 2018 9:58 am
Forum: Installation questions
Topic: requirement for diodes in circuits.
Replies: 1
Views: 114

requirement for diodes in circuits.

The OEM vehicle wiring diagrams show diodes being fitted to a number of circuits, in particular, some of those that involve the instrument display/combination meters. When replacing or building a instrument display using a dash 2 pro unit as upgrade is there a requirement to embody similar diodes to...
by anthony pearce
Sat Oct 06, 2018 10:43 am
Forum: Pre-sales product questions
Topic: engine system malfunction indicator and warning light.
Replies: 2
Views: 131

engine system malfunction indicator and warning light.

Gents, Being a mechanical rather than electronics engineer , I have problems chasing the amps around the systems. I have a Subaru engine destined to run with an Alkatec ECM and OBD11 interface to Dash2 pro unit. i have gone through the resitor stage of sensor connections etc ok, but have reached a s...
by anthony pearce
Wed Dec 06, 2017 4:24 pm
Forum: Pre-sales product questions
Topic: ecu and dash 2 pro interface.
Replies: 1
Views: 681

ecu and dash 2 pro interface.

Can you confirm the integration of the Dash 2 pro with Alcatek e1502 vo.0.2b /e1502-0269 unit which has "motorsport enabled", and will have a "Toucan" display/ Output. I understand that Alcatek is the latest (2012) version of what was Simtek units.It is being built with Subaru 2l...

Go to advanced search