Try pressing and holding the ‘UP’ button as the unit is turned on, when the fog light comes on release the up button then try to re-flash from the DL1 or PC. Hi, the trick with pressing up button to reflash works out well, but when i use the version "DASH2 customer reflash 9 1 9 090907&quo...

ThomasLE71 wrote:I think this has been answered in this thread:

http://www.race-technology.com/forum/viewtopic.php?t=1741

Best regards,
Thomas

Problem solved, thanks.

/Pär

Hi, where do i set the "GPS speed accuracy" in variable manager?

My Dash2 stopped working after a reflash.
Now i can't reflash it eihter by DL1 or Com1. Is there any way of reset the Dash2 or push up new firmware?

/Pär

Make sure that when you are testing with the lite monitor software you are connecting to it at 115.2kbaud. The connection speed between the ECU and the ECU interface is nothing to do with this speed. You should see either valid ECU data if there is any, or nothing if there isn’t. Which MBE ECU ar...

I have now checked the rpm signal with an oscilloscope and the signal looks very fine. A square 5v signal. Is it possible to use 5v signal to Dash2 RPM input?

/Pär

I’m using DL1, Dash2 together with an MBE ECU serial interface and I can’t get it to work. The DL1 and Dash2 is communicating but I can’t show any data from the ECU on Dash2. If I use Lite Monitor I just get a lot of error and no correct data from ECU. The ECU is configure to use 16Bit and 192...

You said a v8 in a e30? Which V8? - this implies an engine swap. If your ECU isn't picking up the proper input signals it will cap speeds. Assuming that your install works properly.... (and it sounds like it is per your video) You can play with the # of pulses per rev to get your dash properly scal...

Hi,
I’m running a DL1 and Dash2 in my BMW M3 e30 V8. From the MBE 970 ECU RPM pin I have connected the Engine speed input to Dash2. The problem is that the Dash wont show revs over 2511RPM. Under 2511 It seems to work well. Any ideas?

http://www.youtube.com/watch?v=I2bQ8dFU1kI

Setup screen:
http://www.ederacing.se/media/Dash2_RPM.jpg

Regards
Pär Hellqvist

Can you email me the latest firmware for the DL1 with 2 green connector blocks and DASH2 please?

Pär
par@ederacing.se
www.ederacing.se

Hi,
can you please send me the latest firmware for a DL1 Mk1 (Green connector blocks) and Dash2.

par(at)ederacing.se

Thanks
Pär

Hi,
can you please send me the latest firmware for a DL1 Mk1 (Green connector blocks) and Dash2.

par(at)ederacing.se

Thanks
Pär

Without knowing details of the signals it is difficult to say. It could be that the pulses going to the DASH2 are very short and that over 2700rpm they just get too short and it can't see them. Do you have any way to view the signals such as an oscilloscope? Martin I dont have any oscillioscope, is...

Hi,
i have a problem displaying RPM on my DASH2. The DASH2 displays the RPM up to aprox 2700 after that the RPM scale goes down to 0 RPM and stays there until the engine revs under 2700.

Any ideas?

Reg
Pär