Cheers for that , will try the 500ohm resistor

Ive only got 2 other sensors oil press and oil temp from race tech
the rest are off ecu

Think my biggest prob will be getting readings for a calc as dont use car much

Cheers Adam

Right got all connected up , tested resistance across sensors before connected and got 55ohms, jacked the up car to see any fluctuation and did see a change ie went down to 51ohms before adding 1k resistor. Ive put a 1k resistor across and connected upto lite monitor, shows around 0.014v ish tried j...

Think I will give the 1k resistor a try gets some logs and see from there

Any more tips

Cheers Adam

Seem to have 6.1 ohms across the 2 senders Thats with around about 3/4 to full tank So would pressume a 10k resistor to get amps down to 120mAmp is that correct Cheers Adam Are you sure that is not 6.1 K ohms? It's easy to have the wrong setting on your volt meter....... Not sure mate will have a l...

Im sure black/white is 12v mate

Will check and let you know later

Ad

Seem to have 6.1 ohms across the 2 senders

Thats with around about 3/4 to full tank

So would pressume a 10k resistor to get amps down to 120mAmp is that correct

Cheers Adam

Support

Does the above sound right with the drawing from my link

Thanks Adam

So would you connect across them as a 2wire with a 10k resistor
then log and see how it goes?

cheers Adam

I had this problem , its a wire shorting on the back of the dash cover

Sent back to Race-tech and they sorted it

Anyone??

you can see the wiring diagram in the link above , left hand pic

Cheers Adam

http://www.lancerregister.com/reg_carde ... ion=edit#/

theres a pic in here

Hi Guys

Still trying to get my fuel level on my Dash2 from my DL1
Ive found a wiring diagram for my car (mitsi evo) but the diagram seems to show 2 senders??

Any help would be very appreciated

Not sure how to post pics [/img]

I also have another issue, when I set the dash2 config rpm bit to 1 pulse per rev its fine on the dash , but in analysis the speed and revs are 1/2 what they should be

Any ideas

Cheers adam

Right box x input + is def 0.001

And bottom box -1 , with that config it shows 655.04 on tickover

Without the -1 its 0.65 but still showing +1 bar

Cheers Adam

Will check tomorrow Dan

See if we can get to the bottom of it