Hi All

In the 'General' window with data displayed (Using analysis 8.5) rather than adding track markers etc to split the data file up, is it possible to do a 'Dynamic Zoom' into an area of data?

I assume it can, just cannot seem to find it.

Thanks

Bill

Thanks for the reply, but its not the track map but the data set I need to shift. I have just played with the method you mention which has offset the track map itself but not the data. http://members.dodo.com.au/~wm1145/RT_overlays.pdf If the image works, you can see the difference between the red a...

Hi All I have looked but cannot seem to find the answer. I have some data from the weekend from a local hillclimb. Trouble is there is an offset in the quick graphs between the two data sets. I assume that the default plots are agains distance, from where, or is this GPS poisition?? Irresepective, I...

Tried reseating all the plugs with no luck. Still no data from the DASH2 to the DL1 ECU Serial data yes, DASH2 Analouge data -No.

Bill

Hi

It is all RT stuff, and hooked up as per their diagrams. I will check the seating of the 2 9 pin plugs to make sure they are fully seated and hope that that is the problem.

Ta

Bill

Hi I have a DASH2, DL1, + ECU interface set up. The DL1 captures the data from the ECU fine, and the DASH2 displays the ECU data fine. What doesnt seem to work, is the DL1 capturing the DASH2 anolouge inputs. I have these connected to capture fuel level, water temp etc but in 'Analysis' it indicates...

Hi All I have just run my DL1/Dash2 combo in anger for the first time. In reviewing the data I noticed that the max RPM in the data log was just under 7000rpm. Yet I was shifting when all the shift lights came on which should have been at 7600rpm. The Dash is feed the Rpm from the ECU on a dedicated...

Found a plug issue which I have replaced and I think resolved the issue.

Cheers

Bill

Hi Osborni

The decode box is ticked. Just had a look with the monitor tool and all channels from the ECU are static. I either have an ECU issue or an ECU adaptor issue.
Starting to look into these now.

Cheers

Bill

Thanks, Now just need to find out why thay are all 0...


Bill

Hi All This will probably be a 'nubie' question (which I am). I have just installed a DL1, DASH2, Serial interface package and am trying to get something to work. I have disabled all direct inputs to the DL1 (as they are not connected). I have enabled GPS + accelerometers + serial feed. If I press t...