Hi there...
I'm the newest Dash2 owner in the world
and am absolutely ecstatic over this little beauty.
Had no trouble getting all the goodies to work just fine, the software is well written and easy to understand, calibrating the readouts are so easy....
I do have a small little problem though...
I, for the life of me, can not figure out how to get the first little green RED on the top to activate. went through the manual and could not find anything that refers to how these LED's can be activated or de-activated by themselves... Setting brightness does not have any effect on the problem....
Please advise..
Kind regards
Michiel
JMJ Sportcars
Gearshift LED1 activation.
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 194 guests