Race Technology

Hi,

Had a look at the Knowledge base and searched on here but can't find a solution.

I have a Dash 2 & DL1 that I've recently installed in my Caterham. RPM on the dash 2 works perfectly but isn't being logged on the DL1. What am I doing wrong?

I'm using the GPS for speed which is being displayed and logged but when I look at the CSV output of the logged file RPM is 0.

Any help would be appreciated.

Colin

If you have the RPM going to the DASH2, not the DL1, then you need to "tell" the DL1 to take RPM from it's data port, not it's own input. To so this you need to configure the DL1 to say "disabled" for RPM on the memory card and serial port. Doing this disables the DL1's own internal RPM input and so it logs the DASH2 input instead - if that makes sense!!

Thanks,

Support - Andy