DL1 analogue
Posted: Sat Jan 04, 2014 2:37 pm
I've wired up a temp sensor with a 1K pull up resistor
According to my multimeter I have 3.8 volts across analogue 1 to earth
Live monitor lite says the value is 57.8
I've swapped it to analogue 2 and the reading moves with it
guessing i have a configuration issue, but really not sure
lost 8 hours of my life on this and getting nowhere
According to my multimeter I have 3.8 volts across analogue 1 to earth
Live monitor lite says the value is 57.8
I've swapped it to analogue 2 and the reading moves with it
guessing i have a configuration issue, but really not sure
lost 8 hours of my life on this and getting nowhere