RPM on DASH4PRO is half of the value on LiteMonitor
RPM on DASH4PRO is half of the value on LiteMonitor
DASH4PRO with DL1PRO and CAN interface. RPM from CAN exactly visible in LiteMonitor. But on the DASH4PRO is only half of the right value. Low and Hi external inputs disabled. RPM only from CAN.
Hi There,
I believe the issue will be lying within the pulses per revolution setting in the DASH4 PRO configuration you have created. When connecting to and using ECU RPM via an interface this should be set to one pulse.
To change this go to Configuration > RPM and change the value to 1.
Send the configuration to the unit and this should solve the issue.
If you are still seeing the issue after going through the above steps, please feel free to email me directly and I shall do my best to help.
sam@race-technology.com
Kind Regards,
Support (SK)
I believe the issue will be lying within the pulses per revolution setting in the DASH4 PRO configuration you have created. When connecting to and using ECU RPM via an interface this should be set to one pulse.
To change this go to Configuration > RPM and change the value to 1.
Send the configuration to the unit and this should solve the issue.
If you are still seeing the issue after going through the above steps, please feel free to email me directly and I shall do my best to help.
sam@race-technology.com
Kind Regards,
Support (SK)
______________________________
Posted by Race Technology Support
Posted by Race Technology Support
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 12 guests