DTA E48 with DASH 2
DTA E48 with DASH 2
Hi has anyone managed to get the dash 2 working with the DTA E48. i have set up the data stream as per the RT guide and connected the dash 2 to the ECU correctly as per the instructions but it does not seem to output any of the ECU channels. i am specifically looking for water temp so i set it up using V8.5 of the software and selected the correct ECU channel from the drop down. am i missing something out as both ECU and dash 2 are being powered correctly and both work fine independently so i thought it would be a simple case of connecting them together once everything had been set up. i am getting all the correct voltages and all the serial cables have good continuity. any help would be appreciated.
-
- Posts: 74
- Joined: Mon Aug 17, 2015 9:36 am
Re: DTA E48 with DASH 2
Hello,
Okay so if it's possible can you send the confg file that is loaded onto the dash currently and the map file currently loaded on the ECU to my email:
daniel@race-technology.com
I can take a look at them and double check everything is set up correctly for communication.
Kind regards,
Support (D)
Okay so if it's possible can you send the confg file that is loaded onto the dash currently and the map file currently loaded on the ECU to my email:
daniel@race-technology.com
I can take a look at them and double check everything is set up correctly for communication.
Kind regards,
Support (D)
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 89 guests