REV Counter not working on dash 2
Posted: Thu Jul 07, 2016 8:48 am
Hi guys,
I hope you are all well? I'm trying to get my rev counter working on my dash 2, the feed is from the OMEX 600 pin 12c.(tacho) to pin 2 top connector (solid white wire) on the dash 2 unit. In the menu I have rpm feed set to R232 YES, Dash 2 NO.
I'm not getting anything on the display, not even at cranking or idle.
Have I missed anything?
All the best
Alex
I hope you are all well? I'm trying to get my rev counter working on my dash 2, the feed is from the OMEX 600 pin 12c.(tacho) to pin 2 top connector (solid white wire) on the dash 2 unit. In the menu I have rpm feed set to R232 YES, Dash 2 NO.
I'm not getting anything on the display, not even at cranking or idle.
Have I missed anything?
All the best
Alex