aem series 2 with Dash2 pro can issues
Posted: Wed Aug 17, 2016 3:41 pm
Hi.
I am trying to setup comunication between a AEM series 2 pnp ecu for honda s2000 with a Dash2 pro display.
This car and all parts was purchased by a former owner and was never installed.
the new owner has asked me to install and finish the car but now in the end I am struggeling with the can comunication.
as I understand it the Dash2 pro has 2 can lines, but they are locked as standard and its an upgrade?
when checking old documentation from the purchase of the parts the upgrade for : gps+accel+logging
I cant find anything on the recips regarding CAN upgrade, is there a way of checking this in the unit?
And if the can lines should work I would need some suport with the CAN protocols.
I hope someone could give me some answers as the car is completed and ready for its first track time.
Best regards
Peter
I am trying to setup comunication between a AEM series 2 pnp ecu for honda s2000 with a Dash2 pro display.
This car and all parts was purchased by a former owner and was never installed.
the new owner has asked me to install and finish the car but now in the end I am struggeling with the can comunication.
as I understand it the Dash2 pro has 2 can lines, but they are locked as standard and its an upgrade?
when checking old documentation from the purchase of the parts the upgrade for : gps+accel+logging
I cant find anything on the recips regarding CAN upgrade, is there a way of checking this in the unit?
And if the can lines should work I would need some suport with the CAN protocols.
I hope someone could give me some answers as the car is completed and ready for its first track time.
Best regards
Peter