Dash2 PRO CAN transmission
Posted: Thu Dec 29, 2016 8:59 pm
Anyone actually used the CAN output back to an ECU?
I have a DASH2 Pro, main signals on CAN 1 from my SImtek ECU, but cetain things wired to the dash analogue I could do with on the ECU (Fuel pressure/EGT/Oil pressure/GPS road speed) but cannot get the system to work.
I can monitor live CAN data in the ecu but I get nothing.
I have copied the RT addresses from the CAN outputs, enabled them and given them a sampling rate, added them to my ECU telemetry input per channel but get nothing.
On the top of the RT CAN output setup it gives an option of 11/29bit messages, yet in the instructions it states that all RT transmissions ore 29bit.
I send CAN to the dash in 11bit from the ECU, but do I need to have the dash in 29bit? why the option if RT needs to transmit in 29bit?
I have only tried it in 11bit so far.
Thanks
Mark
I have a DASH2 Pro, main signals on CAN 1 from my SImtek ECU, but cetain things wired to the dash analogue I could do with on the ECU (Fuel pressure/EGT/Oil pressure/GPS road speed) but cannot get the system to work.
I can monitor live CAN data in the ecu but I get nothing.
I have copied the RT addresses from the CAN outputs, enabled them and given them a sampling rate, added them to my ECU telemetry input per channel but get nothing.
On the top of the RT CAN output setup it gives an option of 11/29bit messages, yet in the instructions it states that all RT transmissions ore 29bit.
I send CAN to the dash in 11bit from the ECU, but do I need to have the dash in 29bit? why the option if RT needs to transmit in 29bit?
I have only tried it in 11bit so far.
Thanks
Mark