Page 1 of 1

DL1 Pro not recording frequency

Posted: Wed Apr 12, 2017 5:23 pm
by jeffnickel
I am trying to setup my DL1 to record a wheel sensor on FREQ1 input. I have it on my bench with a 75Hz square wave input with 12V amplitude to Pin "T" of the 19 pin connector. I get no frequency data in the file. Also, the first three analog inputs do collect but only at 100Hx NOT at 1KHz as configured. Any ideas what might be wrong?

I have tried to attached my config file, DL1.CMG, but I get a error message saying my file has an incorrect extension??? Tried removing the extension but no luck???

Thanks,
Jeff (Newbie)

Solved: DL1 Pro not recording frequency

Posted: Wed Apr 12, 2017 7:05 pm
by jeffnickel
After reformatting the SD card twice and loading config file the DL1 logged the data correctly.
Thanks,
Jeff