Does anyone have a config file for a Link to Dash2 (not pro) via CAN please?
Would save me putting them all in.
Thanks!
Link G4+ and Dash2
-
- Posts: 21
- Joined: Sat Oct 15, 2011 7:05 pm
- Location: Lancashire
Link G4+ and Dash2
is200tt.co.nr
-
- Posts: 21
- Joined: Sat Oct 15, 2011 7:05 pm
- Location: Lancashire
Re: Link G4+ and Dash2
Right I’ve got the two units talking.
But can I set the Dash2 (not pro!) to read custom CAN data? For example the lambda signal isn’t on the pre set Vipec/link drop down.
But can I set the Dash2 (not pro!) to read custom CAN data? For example the lambda signal isn’t on the pre set Vipec/link drop down.
is200tt.co.nr
-
- Posts: 74
- Joined: Mon Aug 17, 2015 9:36 am
Re: Link G4+ and Dash2
Dear Sir / Madam,
In this installation you should have one of our 'CAN adaptors' installed between the dash and the ECU.
If you send me an email (daniel@race-technology.com), I'll send you the LINK G4+ file we have on our system for the CAN adaptor, this contains lambda 1 as a preset variable. Try this file and see how you get on.
Best regards,
Support(D)
In this installation you should have one of our 'CAN adaptors' installed between the dash and the ECU.
If you send me an email (daniel@race-technology.com), I'll send you the LINK G4+ file we have on our system for the CAN adaptor, this contains lambda 1 as a preset variable. Try this file and see how you get on.
Best regards,
Support(D)
-
- Posts: 21
- Joined: Sat Oct 15, 2011 7:05 pm
- Location: Lancashire
Re: Link G4+ and Dash2
Have just emailed thanks. Didn’t get a reply notification so sorry for the delay
is200tt.co.nr
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 16 guests