Dash 2 to omex 600 problem
Posted: Sun Jan 07, 2018 2:53 pm
Pulling my hair out over this one and I suspect it's something simple.
Just wired the analogue channels into the brand new dash 2, oil and fuel and they work ok but the dash won't read anything coming from the omex600
In map4000 I've set up the serial channel exactly as per the knowledge base, the only input I don't have is lambda 2 but I've just selected something else for that.
Then on the dash 2 I've entered the ECU interface and selected the ones I want
But the values do not show on the screen, they are just zeros
I can't find anything else in the map4000 software to enable anything and I'm stuck. I haven't changed any of the ECU wiring and I'm simply using the aerial adapter thing that was sent with the dash
Any ideas folks?
Just wired the analogue channels into the brand new dash 2, oil and fuel and they work ok but the dash won't read anything coming from the omex600
In map4000 I've set up the serial channel exactly as per the knowledge base, the only input I don't have is lambda 2 but I've just selected something else for that.
Then on the dash 2 I've entered the ECU interface and selected the ones I want
But the values do not show on the screen, they are just zeros
I can't find anything else in the map4000 software to enable anything and I'm stuck. I haven't changed any of the ECU wiring and I'm simply using the aerial adapter thing that was sent with the dash
Any ideas folks?