Link G4+ extreme ecu and Dash 2 not receiving CAN
Posted: Fri Aug 17, 2018 7:03 pm
So to save thread crapping other peoples threads ad problems I’ve started my own..
So the issue is I can’t read read CAN information from my ecu on my Dash 2 display
My set up is:
Link G4+ extreme ecu
Link CANF connector
RT CAN interface lead pre programmed with link g4+ ecu
Dash 2 display
I installed the CAN interface lead by commenting the terminator connector to 12+ and ground in the loom, then put a Link CANF connector on the can port serial plug.
Using firmware 10 0 6 when I connect the display t the interface lead I get “0” for water temp, AIT readings etc
When I use 9 3 5 firmware, I don’t get any readings or numbers at all, but I now know that it should be version 1 beng used.
Any ideas why I’m not getting the readings on the display?..
I know that I should be using v10 firmware, from reading other information on here!
Any help would be appreciated
Cheers
So the issue is I can’t read read CAN information from my ecu on my Dash 2 display
My set up is:
Link G4+ extreme ecu
Link CANF connector
RT CAN interface lead pre programmed with link g4+ ecu
Dash 2 display
I installed the CAN interface lead by commenting the terminator connector to 12+ and ground in the loom, then put a Link CANF connector on the can port serial plug.
Using firmware 10 0 6 when I connect the display t the interface lead I get “0” for water temp, AIT readings etc
When I use 9 3 5 firmware, I don’t get any readings or numbers at all, but I now know that it should be version 1 beng used.
Any ideas why I’m not getting the readings on the display?..
I know that I should be using v10 firmware, from reading other information on here!
Any help would be appreciated
Cheers