Hello folks,
I have an issue receiving and displaying CAN data from stock BMW(MSS54) ecu . The dash2 pro is licensed for 15 channels , BMW_mini protcol file loaded using the can config window . The dash2 pro had firmware updated and the CAN 15 receive channels is showed as marked after configuration is read .
Here are the ecus connected to the CAN . Motec PDM, DASh2pro, DME. Using a Motec CAN analyzer utility i can see the BMW DME is transmitting data and was able to input and display correct data into the PDM .
I have used 1 and 2 terminating resistors, disconnected PDM , cycled power , re-flashed the DASh and changed configurations several times and still no joy . Wires have been checked and triple checked . At one point while the Dash has displayed correct values . After another configuration which had less Can channels file was written the data was not displayed again on the DaSH.
I really do not know what else to do . Need some help .
Thank you ,
Adrian
Dash2pro CAN_RX Issue
Re: Dash2pro CAN_RX Issue
Hello Adrian - The most likely issue is the CAN protocol loaded on the dash not matching the ECU. I need to look at the dashes configuration, would you please: Read back the configuration from the unit, save the configuration file then email it to me for inspection? (daniel at race - technology dot com)
Thanks
Thanks
______________________________
Posted by Race Technology Support
Posted by Race Technology Support
Re: Dash2pro CAN_RX Issue
Hello Daniel ,
Config file sent .
Thank you
Config file sent .
Thank you
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 18 guests