Hi,
It would be very handy if it was possible to get a time stamp when starting to log data. I use other data collection devises and when synchronising the two files, if I do not turn on the DL2 at exactly the same time. It is hard to match up the two sets of data.
The initial time stamp could be taken from the GPS. To save memory only the first time stamp would be needed. After that the time could be calculated as required ??
I see you have GPS time in sec. Could that be used ? Does that count in sec from 00:00:00 (midnight) ?? Does not look that way due to the large number
Acquire Time stamp
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 156 guests