Upload Calibration & Lost ECU CAN Interface Data

Moderators: jlucas, RTUSA, kieran

Jordysport
Posts: 2
Joined: Tue Feb 06, 2018 6:26 pm

Upload Calibration & Lost ECU CAN Interface Data

Postby Jordysport » Wed Feb 07, 2018 9:29 am

Bit of a back story,

Had the Dash fitted professionally (along with all the new wiring loom) with the ECU interface (Hondata Specific) and it all worked fine (except the calibration) which he could not do there and then. so since i have been sent a calibration (For things such as Fuel Level etc) I added to that calibration with Gear Ratio's, Two Alarms and setting Rev lights.

I then went to upload the calibration to the dash it was unplugged at the serial port nearest the dash (unplugging the ECU interface) the Calibration was then uploaded via serial cable and USB adapter, it was uploaded successfully. All was well i thought. I then plugged the ECU interface back in and tested it to find Coolant temp and Battery on the dash reading 0.

any suggestions would be much appreciated.

Display is a DASH2 with updated firmware newer than v10

racetec
Site Admin
Posts: 111
Joined: Thu Oct 27, 2005 12:02 pm

Re: Upload Calibration & Lost ECU CAN Interface Data

Postby racetec » Wed Feb 07, 2018 9:51 am

It sounds like a simple error in the 2nd configuration that was supplied form the garage... I would simply ask them to check it in the first please.

Jordysport
Posts: 2
Joined: Tue Feb 06, 2018 6:26 pm

Re: Upload Calibration & Lost ECU CAN Interface Data

Postby Jordysport » Wed Feb 07, 2018 9:55 am

Good Morning, thanks for the quick response,

I've gone through the calibration myself as well, and can't see anything out of place. do you have an email address i could send it to?

Thanks

racetec
Site Admin
Posts: 111
Joined: Thu Oct 27, 2005 12:02 pm

Re: Upload Calibration & Lost ECU CAN Interface Data

Postby racetec » Wed Feb 07, 2018 10:32 am

Hi Jordan

Please email this to support@race-technology.com


Return to “General support questions”

Who is online

Users browsing this forum: No registered users and 3 guests