Hiya guys ive reacently bought a 106 with one of your DASH2 Dials fitted in the car cut a long storie short heres the run down
Bought a 106 maxi shell with the dash fitted
had a standad engine put in for naw to get it running and setup the car etc etc
Naw here where i get confused
I wanna set the level in my fuel tank.
Its using the OEM standad fuel pump/sender for naw untill i can afford better
HAs anyone got like a step by step guide on how to calibirate the fuel level its currently displaying 14........ which as far as i can see is correct..!! BUT
when i orignally tried starting the car with 10 liters of fuel it didnt fire ( not enough fuel for the pick up to pick up ( of you get me) so i put an extra 5 litre's in and she fired.
Is there a way i can caliberate the dash to say when i have '14' litre's of fuel in the tank i really only have '5' before it runs out?
Get me?
Noooobie With Questions
Here:
http://www.race-technology.com/wiki/ind ... FuelSender
and here:
http://www.race-technology.com/wiki/ind ... ensorToDL1
(aside: the knowledge base is quite good, I'd muck around there a bit to learn)
There are a few posts on this forum available for search.
It's basically a DIY job and requires that you have at least a basic understanding of electronics and wiring. Helpful if you know the basics of Ohm's law.
http://www.race-technology.com/wiki/ind ... FuelSender
and here:
http://www.race-technology.com/wiki/ind ... ensorToDL1
(aside: the knowledge base is quite good, I'd muck around there a bit to learn)
There are a few posts on this forum available for search.
It's basically a DIY job and requires that you have at least a basic understanding of electronics and wiring. Helpful if you know the basics of Ohm's law.
BMW 2000 M Coupe
-
- Posts: 9
- Joined: Sun Jan 16, 2011 7:54 pm
- Location: Welwyn Garden City, Herts.
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 50 guests