Race Technology

For some reason my lat/long accel values are always a fraction of what they should be... I've looked through all the settings and can't find anything that would cause this. My numbers are somewhere around 1/8 to 1/10 of what I would expect them to be. I've compared data with a friend from the same track at the same time and his numbers are fine. Any ideas?

Thanks

Might be worth trying the folllowing simple test: (assuming you have the DL90/DL1)

Connect the logger to a PC and run the monitor software. Slowly tilt the logger vertically through 90 degrees (so its standing upright) the G values should rise to + or - 1G depending on the tilt axis. Try both axis and report on what values you get. You could always log this normally and analyse the data later post the charts.

HTH

...are you sure you've got the sortware reading the correct units? There is a factor of 9/8 between units of g and m/s/s.

Support

I tried tilting it with the Dash1 attached (don't have my laptop here at work). The G values never rised above 0.12.

By, "correct units" is this a setting in the analysis software? Where is this setting? I can load in a firends run file into the same raf file with my runs and his runs have the correct G's and mine does not.

Thanks

Try checking:

Data - Variable Manager - Standard Variables

Units are set to [g] for both lat and long accel. This wouldn't explain the fact that other run files have expected G values when mine do not, in the same Analysis session... Would it?

Maybe I just have a bad unit or need new firmware or something?

Thanks