Dear RT,
I have recently started using a DL1 + Dash3. Currently running it from the supplied 230V mains adapter, busy setting up. After programming the 'S' button on the Dash 3 to start & stop logging, and using it to check the operation, I had a look at the .RUN file in the RT analysis sw.
In the Run Details it states "... Logging stopped for reasons unknown, possibly loss of power. Logging stopped by source 54. "
I've also started and stopped logging using the button on the DL1. The Run Details then change to "... Logging stopped for reasons unknown, possibly loss of power. Logging stopped by source 17. "
I am puzzled. And worried a bit too. I would not like to find out after a training sessions or race that no data has been recorded, so:
Does anyone know why the logger does not recognize the 'stop' command from the Dash3 or the DL1 ?
with regards,
Alex Schoots
Run details show "Logging stopped for reasons unknown&q
I am getting the same message
, using firmware version 28-6. Data logged on 15/03/2010 @ 21:07. Logging started by button press. Logging stopped for reasons unknown, possibly loss of power. Logging stopped by source 17.Logger serial number: 4206. Run Contains 53364 individual data samples, and 80 data formatting errors.
I started and stopped the logging with the button on dl1. Do you know more about this?
I started and stopped the logging with the button on dl1. Do you know more about this?
I've already made Martin aware of this issue. Nothing to be concerned about as it won't impact the operation or your usage in analysis. They'll get it sorted in a future firmware.
Jeremy Lucas
Fast Tech Limited - a Race Technology Dealer
Fast Tech Limited - a Race Technology Dealer
Great news:-)
Can you or anybody shed some light on why it says :" ...80 data formating errors". Should I care?
Sorry I can't answer that one, only RT can.
Jeremy Lucas
Fast Tech Limited - a Race Technology Dealer
Fast Tech Limited - a Race Technology Dealer
Sorry - I completely missed this one. Please download the latest softwae from the web site - I think this will remove these errors. If it doesn't then please email me the run file and I'll check in more detail (andrew@race-t******g.com). A few errors don't cause any problems, but typically there should only be a 1 or 2 at the end of a file.
Thanks,
Andy
Thanks,
Andy
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 41 guests