I tried to do but got the message "Failure! Command Timeout "
What to do to make it run?
Cheers
Chris
Dash3 - Add Track Markers
It is the first time I tried to add markers on a normal ride through the country side.
I have assigned a button to do this and after pressing the message occurred.
The whole equipment is very new, I bought it by Emotag Germany and they told me that the newest firmware was put on.
The equipment is now 2 month old.
Cheers
Chris
I have assigned a button to do this and after pressing the message occurred.
The whole equipment is very new, I bought it by Emotag Germany and they told me that the newest firmware was put on.
The equipment is now 2 month old.
Cheers
Chris
An hour ago I was out with the car again for testing to make markers.
I did switch on the equipment OUTSIDE the garage and look at that, the Dash3 did make about 10 markers down the road and back.
Does it make a difference if the loggers are switched on inside a garage or pit and then I drive outside or do I have to switch it on outside the pits?
Cheers
Chris
I did switch on the equipment OUTSIDE the garage and look at that, the Dash3 did make about 10 markers down the road and back.
Does it make a difference if the loggers are switched on inside a garage or pit and then I drive outside or do I have to switch it on outside the pits?
Cheers
Chris
You should only start logging after you have GPS lock.
I use the autostart based on speed (DL1 Configure Speed >500; note the units are in 1/10 kph) for my track use, that insures I have GPS lock and that I don't get log files just moving the car around in the paddock.
I use the autostart based on speed (DL1 Configure Speed >500; note the units are in 1/10 kph) for my track use, that insures I have GPS lock and that I don't get log files just moving the car around in the paddock.
Jeremy Lucas
Fast Tech Limited - a Race Technology Dealer
Fast Tech Limited - a Race Technology Dealer
jlucas wrote:You should only start logging after you have GPS lock.
I use the autostart based on speed (DL1 Configure Speed >500; note the units are in 1/10 kph) for my track use, that insures I have GPS lock and that I don't get log files just moving the car around in the paddock.
I also use the autostart at 20 kph it should be starting.
Next weekend is the first try at Zandvoort - I hope it works.
The test rides are promising:
http://www.youtube.com/watch?v=mXidXhMCIhk
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 21 guests