No RPM data in .run file (DL1)

Tim.Wright
Posts: 3
Joined: Fri Jul 28, 2006 3:50 pm

No RPM data in .run file (DL1)

Postby Tim.Wright » Fri Jul 28, 2006 3:55 pm

Hey people,

I have been testing my initial installation of a DL1 and I'm unable to retrieve the RPM data from the log. The RPM signal is definately getting to the logger as it shows on the monitor program, but when I stream the data and graph RPM vs time I get a straight line at 500 RPM.

Maybe I'm using the software wrong, but I have been starting at it for a few hours and am getting nowhere.

Any help would be appreciated!

Tim

RTUSA
Site Admin
Posts: 457
Joined: Fri Feb 24, 2006 7:34 pm
Location: Richmond, VA, USA

Postby RTUSA » Mon Jul 31, 2006 4:49 pm

In the Analysis program, under Data > Variable Manager > External Inputs, make sure RPM is enabled.

Also, try logging a run to the CF card and see if you get the RPM that way.

Make sure that you have not disabled RPM logging in the DL1 config utility (though the fact you can see in Monitor suggests not, for the serial port anyway)

And, are you running relatively recent V6 software?
Al Seim
Race Technology USA


Return to “General support questions”

Who is online

Users browsing this forum: No registered users and 49 guests