Help with dash2 dl1 and can interface

farmer1978
Posts: 1
Joined: Sat Mar 24, 2012 3:59 pm
Location: aberdeen

Help with dash2 dl1 and can interface

Postby farmer1978 » Thu Mar 29, 2012 10:09 pm

Can someone help me please I have a dash 2 linked to a dl1 to a mbe 9a4 through a can interface. oil pressure, oil temp and fuel pressure sensors also I have them working but The dash 2 is not showing the info from the ecu I have tryed to configure it myself but struggling to get it to work, Can someone email me configeration files for all 3 to work together.

racetec
Site Admin
Posts: 326
Joined: Thu Oct 27, 2005 12:02 pm

Postby racetec » Wed Apr 25, 2012 9:41 am

Have you tried looking at the output of the ECU interface on a laptop using the lite monitor software? If not that is the first thing to do, this will make sure that the ECU interface is working correctly and is decoding the ECU information from the CAN bus.

Also check that you have your ECU set up as shown here: -

http://www.race-technology.com/wiki/ind ... 4AndMBE992

And double check the wiring on the CAN cable to make sure that the wires on the ECU match up with the wires on the CAN interface, the MBE ECU uses a non-standard pinout for the CAN connections.

Thanks, Martin.


Return to “General support questions”

Who is online

Users browsing this forum: Bing [Bot] and 54 guests