Help with dash2 dl1 and can interface
Posted: Thu Mar 29, 2012 10:09 pm
by farmer1978
Can someone help me please I have a dash 2 linked to a dl1 to a mbe 9a4 through a can interface. oil pressure, oil temp and fuel pressure sensors also I have them working but The dash 2 is not showing the info from the ecu I have tryed to configure it myself but struggling to get it to work, Can someone email me configeration files for all 3 to work together.
Posted: Wed Apr 25, 2012 9:41 am
by racetec
Have you tried looking at the output of the ECU interface on a laptop using the lite monitor software? If not that is the first thing to do, this will make sure that the ECU interface is working correctly and is decoding the ECU information from the CAN bus.
Also check that you have your ECU set up as shown here: -
http://www.race-technology.com/wiki/ind ... 4AndMBE992
And double check the wiring on the CAN cable to make sure that the wires on the ECU match up with the wires on the CAN interface, the MBE ECU uses a non-standard pinout for the CAN connections.
Thanks, Martin.