My current setup is a MK1 DL1 - DASH4 Pro - OBDII Interface.
My current issue is that I can't get the shift lights to work on the DASH4. I'm getting RPM values from the OBDII interface. I have set the pulses-per-revolution to 1 (as I had to do in the Analysis software), but I still can't get it to work. At the moment the shift lights are set as standard on the DASH4.
Any thoughts?
DASH4 Shift Lights with OBDII Interface
-
- Posts: 27
- Joined: Wed Apr 11, 2012 6:27 pm
- Location: Houston, TX
-
- Posts: 27
- Joined: Wed Apr 11, 2012 6:27 pm
- Location: Houston, TX
Re: Support
Support wrote:Hello,
Are you able to display RPM as a numerical value?
Yes, and it matches quite well.
Support wrote:What is the firmware version you are running?
Support (K)
DASH4: 1.0.21
DL1: 33-5
-
- Posts: 27
- Joined: Wed Apr 11, 2012 6:27 pm
- Location: Houston, TX
-
- Posts: 27
- Joined: Wed Apr 11, 2012 6:27 pm
- Location: Houston, TX
Re: Support
Support wrote:Should work fine with that firmware.
Please can you email me your DASH configuration .HEX file to kieran@race-tech... and i will investigate further.
Kind regards,
K
email sent!
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 26 guests