Megasquirt MS3 again, CAN can work now!!
Posted: Fri Apr 18, 2014 4:10 pm
Hi gents,
I would like to ask the support team to look into the following document and ask a programmer to give some feedback too. MS3 and MS2 are with their newest firmware finally able to send CAN commands according to a standard protocol.
http://www.msextra.com/doc/general/file ... -03-10.pdf
This is great news. Can somebody tell me if your CAN adapter can be configured to run with it? should be possible, actually. But what needs to be setup?
regards, Thomas
I would like to ask the support team to look into the following document and ask a programmer to give some feedback too. MS3 and MS2 are with their newest firmware finally able to send CAN commands according to a standard protocol.
http://www.msextra.com/doc/general/file ... -03-10.pdf
This is great news. Can somebody tell me if your CAN adapter can be configured to run with it? should be possible, actually. But what needs to be setup?
regards, Thomas