Connecting Dash2 to Computer with v8.5
Posted: Fri Sep 04, 2015 10:01 am
This is my first time trying to do anything with Dash2 and the Configuration software. Thanks for your help!
I've purchased the car with a Dash2 in it, and want to modify the settings.
I've downloaded version 8.5 of the configuration software (loads up as Dash2PRO COnfiguration v4.0.56 so I assume that is the right one? - seemed weird that it was Dash2PRO version when I only selected Dash2 so I assume the config software for them is the same?).
The config software has a button "Read Configuration" which I assume downloads the settings from the dash (the original configuration file was not passed on to me by the previous owner).
When computer is connected to the Dash2 and the dash is powered up, I push the "read configuration" button in the software and it thinks for a while, then pops up an error "System getting live USB data and please restart device and try again".
Turning Dash on and off again, disconencting serial cable and reconnecting etc, still returns same error message.
Dash2 firmware 9.0.9. Installed in a Rally car - no data logging or other units that I am aware of. Talks (somehow) to a LINK G4 ECU for data inputs like oil, water. Pretty simple setup I guess.
Dash2PRO config software communications setting is set to the same data speed as the serial cable under its properties.
As per another post on here, I downloaded Version 8 of the config software to see if that would work, however this has no button to read settings from the dash. There was another post on here with a response from a support tech person dated from April this year confirming this is not possible - I assume because the software was improved since then when V8.5 was released with this function?
Any help appreciated!
I've purchased the car with a Dash2 in it, and want to modify the settings.
I've downloaded version 8.5 of the configuration software (loads up as Dash2PRO COnfiguration v4.0.56 so I assume that is the right one? - seemed weird that it was Dash2PRO version when I only selected Dash2 so I assume the config software for them is the same?).
The config software has a button "Read Configuration" which I assume downloads the settings from the dash (the original configuration file was not passed on to me by the previous owner).
When computer is connected to the Dash2 and the dash is powered up, I push the "read configuration" button in the software and it thinks for a while, then pops up an error "System getting live USB data and please restart device and try again".
Turning Dash on and off again, disconencting serial cable and reconnecting etc, still returns same error message.
Dash2 firmware 9.0.9. Installed in a Rally car - no data logging or other units that I am aware of. Talks (somehow) to a LINK G4 ECU for data inputs like oil, water. Pretty simple setup I guess.
Dash2PRO config software communications setting is set to the same data speed as the serial cable under its properties.
As per another post on here, I downloaded Version 8 of the config software to see if that would work, however this has no button to read settings from the dash. There was another post on here with a response from a support tech person dated from April this year confirming this is not possible - I assume because the software was improved since then when V8.5 was released with this function?
Any help appreciated!