Gear position from DTA ECU CAN stream
Posted: Thu Sep 22, 2016 10:37 am
Hello,
I would like my Dash2 to display gear position using the gear position sensor which is wired to my DTA S80 ECU.
Is it possible to feed this data to the Dash2 via the CAN stream?
I've established that the ECU will send gear position data to the CAN adapter;
S Series CAN Stream Specification
General
CAN bus Baud Rate 1 MBd
Identifiers All 29Bit
6 Data Packets All 8 Bytes Ea.
Send Frequency 10 - 50Hz
All Data Values 16 Bit Signed Sent LSB First (Little Endian)
Data Packets From V62.01
Identifier Data1 Data2 Data3 Data4
0x2000 RPM TPS % Water Temp C Air Temp C
0x2001 MAP Kpa Lambda x 1000 KPH x 10 Oil P Kpa
0x2002 Fuel P Kpa Oil Temp C Volts x 10 Fuel Con. L/Hr x 10
0x2003 Gear Advance Deg x 10 Injection ms x 100 Fuel Con. L/100Km x 10
0x2004 Ana1 mV Ana2 mV Ana3 mV Cam Advance x 10
0x2005 Cam Targ x 10 Cam PWM x 10 Crank Errors Cam Errors
Regards,
Alex
I would like my Dash2 to display gear position using the gear position sensor which is wired to my DTA S80 ECU.
Is it possible to feed this data to the Dash2 via the CAN stream?
I've established that the ECU will send gear position data to the CAN adapter;
S Series CAN Stream Specification
General
CAN bus Baud Rate 1 MBd
Identifiers All 29Bit
6 Data Packets All 8 Bytes Ea.
Send Frequency 10 - 50Hz
All Data Values 16 Bit Signed Sent LSB First (Little Endian)
Data Packets From V62.01
Identifier Data1 Data2 Data3 Data4
0x2000 RPM TPS % Water Temp C Air Temp C
0x2001 MAP Kpa Lambda x 1000 KPH x 10 Oil P Kpa
0x2002 Fuel P Kpa Oil Temp C Volts x 10 Fuel Con. L/Hr x 10
0x2003 Gear Advance Deg x 10 Injection ms x 100 Fuel Con. L/100Km x 10
0x2004 Ana1 mV Ana2 mV Ana3 mV Cam Advance x 10
0x2005 Cam Targ x 10 Cam PWM x 10 Crank Errors Cam Errors
Regards,
Alex