connecting emerald k6 to dash 2

Khurn85
Posts: 1
Joined: Wed May 30, 2018 6:15 pm

connecting emerald k6 to dash 2

Postby Khurn85 » Thu May 31, 2018 5:44 pm

after telling emerald to send data to dash and telling the dash to accept data from emerald do i just connect both up using the serial cable, i know emerald uses a different pin configuration, but both the dash and the elmerald have male serial connections so do i then use a 'serial adapter' ie male to male to connect the ecu to the dash,sorry if this is incredibly stupid on my behalf
cheers kris

racetec
Site Admin
Posts: 326
Joined: Thu Oct 27, 2005 12:02 pm

Re: connecting emerald k6 to dash 2

Postby racetec » Fri Jun 01, 2018 8:31 am

Hi

You will need our ECU Interface for the dash to receive data from the ECU.
https://www.race-technology.com/gb/raci ... interfaces

Information on connections can be found here:
https://www.race-technology.com/wiki/in ... DK3-K6-M3D

Best regards,
Adele


Return to “General support questions”

Who is online

Users browsing this forum: No registered users and 26 guests