I get info out of the DL1 - different sensors show up fine.
Biggest problem is no usable RPM data. I have a lead off of the diagnostic connector for rpm. Any filtering? It always reads low like 35-65 at idle.
Also, I can't seem to set lap markers. If I use the method of putting a .lap file on the flashcard, when I start logging the dash says something about 4th numbered marker added (there were four markers) but I don't get any indication of crossing the markers.
If I try setting the markers manually from the dash, it just doesn't work. I've set up the "SET" button to be the button for setting lap markers but it doesn't appear to do anything.
Thanks for any help...
Jason
Dash1 probs
Do you have "GSM mode enabled" on your DL1 config? You need that to be able to set markers from the DASH.
Is your DL1 recorded rpm data fine, you just can't see it on the DASH or are both reading low?
Is your DL1 recorded rpm data fine, you just can't see it on the DASH or are both reading low?
Jeremy Lucas
Fast Tech Limited - a Race Technology Dealer
Fast Tech Limited - a Race Technology Dealer
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 239 guests