Posted up for other people to search on as I couldn't find any info on it here or anywhere else when I did mine.
RPM feed - Take from the back of the ODBII port to the right of the driver under the dash (right hand drive car). Pin 9 - Black and Pin 4 - Brown, can't remember which is the + and which the ground but a multimeter will help there.
Throttle - There are 6 cables coming from the throttle pedal, 2 seperate sensors and circuits, one is used for the value, the other for plausability, I've taken the value figure. The wire you want to tap is the plain white wire, this gives values between approx 0.69v at 0 throttle and 4.79v at full throttle.
Brake - just took brake on or off from top of brake pedal, can't remember which and didn't write it down but this was pretty easy.
Steering Angle sensor to come...
Hopefully others will find that useful!
PS. All above on an 03 plate SMG car.
E46 M3 \ M3 CSL wiring
E46 M3 \ M3 CSL wiring
Last edited by _Nathan_ on Fri May 02, 2008 10:19 am, edited 1 time in total.
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 14 guests