Need Help Connecting Serial ECU to a DL1
Posted: Fri Oct 17, 2008 4:53 pm
I finally got my serial ecu connector for my DL1.
However, I am having a problem with it.
When I connect it to the DL1, it locks up the DL1 and the DL1 will not begin logging any data. The three other lights illuminate, but the logging light will not.
Even after I disconnect the Serial ECU connector, I still cannot log data... I have tried three times now.
I am not sure what resets the DL1, but eventually it starts allowing me to log more data.
But, as soon as I plug in the Serial ECU to the DL1, it goes dead again.
I am running firmware version 11-5 in my old style, green connector, DL1 unit.
I checked the 12v power I am supplying to the Serial ECU and the polarity and voltage is correct.
What can I do to make it work??
How do I reset the DL1 when it locks up like this?
I have a race Sunday, so I am hoping I can use it for the race...
Thank you,
Jeff
However, I am having a problem with it.
When I connect it to the DL1, it locks up the DL1 and the DL1 will not begin logging any data. The three other lights illuminate, but the logging light will not.
Even after I disconnect the Serial ECU connector, I still cannot log data... I have tried three times now.
I am not sure what resets the DL1, but eventually it starts allowing me to log more data.
But, as soon as I plug in the Serial ECU to the DL1, it goes dead again.
I am running firmware version 11-5 in my old style, green connector, DL1 unit.
I checked the 12v power I am supplying to the Serial ECU and the polarity and voltage is correct.
What can I do to make it work??
How do I reset the DL1 when it locks up like this?
I have a race Sunday, so I am hoping I can use it for the race...
Thank you,
Jeff