Race Technology

Posted: **Fri May 01, 2009 2:45 pm**

Problem.. Installed new (paired) dash2+dl1
Everything seems to work correctly, except all shiftlights flash rapidly all time and no rpm reading, no gear indicator, gps speed works and all other sensor inputs from dl1 works too.
With lite monitor, i can get rpm out of dl1, so i think there is something wrong with dash, not dl1. I reflashed dash, but still all leds flashes. Dash settings are ok for dl1 speed and rpm. Gear settings are ok too.

They all worked fine at first start, problem started when i first time set new settings for dash (or when i started dash with down-button pressed to see version number) . But now cant get it sorted, tried everything..

Posted: **Fri May 01, 2009 3:44 pm**

In the Dash2 menu structure, is the RPM set to RS232 Yes or No and what is Dash2 RPM set to, Yes or No?

Posted: **Fri May 01, 2009 6:20 pm**

dash2 rpm is set to no, dash2 speed is set to no, rs232 rpm and speed are yes. Tried other settings too, but these should be correct ones.

Posted: **Fri May 01, 2009 6:50 pm**

In the dash2 display config the rpm setup bit

Set the rpm shift light to say 6000rpm :wink:

Posted: **Fri May 01, 2009 8:18 pm**

Adam37tr wrote:In the dash2 display config the rpm setup bit

Set the rpm shift light to say 6000rpm

hmm, worth trying. Could it be so simple.. :shock:

Posted: **Sat May 02, 2009 6:40 am**

Was on mine mate :oops:

Just cant get the ecu serial interface to do anything now

Posted: **Sat May 02, 2009 6:28 pm**

Adam37tr wrote:Was on mine mate

thanks! Problem solved..

shiftlight was set to 0 and pulses per revolution to 0,1
Everything works now when i put correct values..

Race Technology

all shift lights flashing

all shift lights flashing