When I turn the ignition on, why my RT water (coolant) temp will start to count 1,2,3 50,99, 101, etc, etc then stop at 312.00 ??
The value will remain @ 312.00 even the water is dead cold.
I'm using the Bosch water temp formula in the drop down at the dash2 software.
RT water temp sensor problem
osborni wrote:Have you confirmed that it is wired to the DL1 properly? Is the DL1 configured properly? Is the sensor getting power? Good Ground from the sensor?
I don't ave DL1.
The harness came from RT + the sensor. The red connected to dash2
the 5V reference, the white connected to analog dash2 & the black is earth.
Yep there is power and good grn.
NEVER MIND! i FOUND THE PROBLEM.
BY THE THE THE TECH HELPS, THE PATIENT IS DEAD!!
WONDER HOW MANY UNIT THEY SELL ? TERRIBLE....
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 260 guests