I’m using DL1, Dash2 together with an MBE ECU serial interface and I can’t get it to work. The DL1 and Dash2 is communicating but I can’t show any data from the ECU on Dash2. If I use Lite Monitor I just get a lot of error and no correct data from ECU.
The ECU is configure to use 16Bit and 19200Baud.
Here is a small log file from Lite Monitor.
http://www.ederacing.se/temp/test1.zip
Regards
Pär Hellqvist
Just errors from ECU serial interface.
Just errors from ECU serial interface.
Pär Hellqvist
Experience Driving Endurance
Tel +46 (0)8 580 116 35
Fax +46 (0)10 588 64 99
Mobile +46 (0)709 50 40 00
par(at)ederacing.se
www.ederacing.se
Experience Driving Endurance
Tel +46 (0)8 580 116 35
Fax +46 (0)10 588 64 99
Mobile +46 (0)709 50 40 00
par(at)ederacing.se
www.ederacing.se
Make sure that when you are testing with the lite monitor software you are connecting to it at 115.2kbaud. The connection speed between the ECU and the ECU interface is nothing to do with this speed. You should see either valid ECU data if there is any, or nothing if there isn’t.
Which MBE ECU are you using?
Which MBE ECU are you using?
Support wrote:Make sure that when you are testing with the lite monitor software you are connecting to it at 115.2kbaud. The connection speed between the ECU and the ECU interface is nothing to do with this speed. You should see either valid ECU data if there is any, or nothing if there isn’t.
Which MBE ECU are you using?
Ok, i set the lite monitor to 19200baud, just because the ECU i set to 19200.
Will test 115200baud to night.
Is there any firmware updates to this interface?
/Pär
Pär Hellqvist
Experience Driving Endurance
Tel +46 (0)8 580 116 35
Fax +46 (0)10 588 64 99
Mobile +46 (0)709 50 40 00
par(at)ederacing.se
www.ederacing.se
Experience Driving Endurance
Tel +46 (0)8 580 116 35
Fax +46 (0)10 588 64 99
Mobile +46 (0)709 50 40 00
par(at)ederacing.se
www.ederacing.se
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 8 guests