Problem getting battery voltage to display on Dash 2
Posted: Mon Mar 15, 2010 4:21 pm
Hi, I have consulted the forum and foun dtwo similar topics and followed advise but still cannot get the battery voltage to display. This is what I have done and tried a number of variations around this.
Take the voltage (12.63V) and feed into the analogue input on the DL1, Ive used Analogue 8 but this should not make any difference which one is used?
Apply a manual equation y=+1x and make this display on the Dash 2. This then give a number of minus 10612.
I've tried to make this correct with fancy equations but this doesn't work and I understand that the true reading on an anlgue input shold be the voltage.
What am I doing wrong please!?
Testing looms fast.......
Steve
Take the voltage (12.63V) and feed into the analogue input on the DL1, Ive used Analogue 8 but this should not make any difference which one is used?
Apply a manual equation y=+1x and make this display on the Dash 2. This then give a number of minus 10612.
I've tried to make this correct with fancy equations but this doesn't work and I understand that the true reading on an anlgue input shold be the voltage.
What am I doing wrong please!?
Testing looms fast.......
Steve